Soligor Telephoto Adjustment Instructions

---

IF BACK FOCUS ADJUSTMENT IS NEEDED:

Remove the GEARED ring that couples the range-finder and you will see a black ring held by red screws. Mount your Soligor Telephoto Lens to the camera and loosen these red screws. Open the camera back and insert a piece of ground glass in the film channel. Set the shutter on Bulb. Set the lens at infinity and focus through the ground glass at a subject at infinity until that subject is sharp — then tighten the red screws.

To Set Engraved Scale for Viewing From Top of Camera

1. Release set screws on geared coupling ring.
2. Unscrew ring from lens by turning counter-clock-wise (with rear of iens facing you).
3. Screw lens into camera firmly.
4. Loosen 3 set screws on lens mount, and lens will freely rotate into desired position.
5. Tighten 3 set screws firmly.
6. Unscrew lens from camera.
7. Replace geared coupling ring and tighten its set screws.

Use the 'Back' button on your browser to return to the Lens Info menu